Hi, I installed a EVO-ONE with NIS2 T-Harness on a 2010 Nissan Rogue (regular key) along with a REVO ONe RF kit. I was able to program the unit, but upon testing, the fuse in the T-Harness (Red) kept blowing. I narrowed it down to the tap I did to the parking light wire (Cut white wire on power connector in T-Harness and tapped to pink wire with silver dots (wire 71 in wirecolor photos) by driver kickplate). Once I disconnected the tap from the pink/silver dot wire, the autostart worked but parking lights would not go on. The guide states that this is the positve parking light wire and no relay needed. Am I using the wrong wire?
Also, the guide stated to connect purple wire in T-Harness (Arm) to red wire in drivers kick panel, and purple/white wire (disarm) to blue wire in drivers kick panel. However the photos of the wires in wirecolor (wires number 104 red w 2 silver dots and 106 blue w 2 silver dots) referenced are the ones I used. I tapped the wires shown in the photos, but when I autostart, it triggers the vehicle alarm. Are these the wrong wires or does this sound like a programming issue?
Mon compte
EVO-4-SERIES
EVO-9-SERIES
EVO-START
FlashLink Mobile
Audi
Chevrolet
Ford
GMC
Honda
Hyundai
Kia
Mazda
Nissan
RAM
Subaru
Toyota
Volkswagen
Trouver nos produits 
Commander nos produits en ligne
Trouver un 
